The short version of thymosin beta-4 fits in a sentence. The long version — which is the one that helps — is below.
This page was last updated on 2026-04-05 and is reviewed periodically as new material appears.
Identity and purity are assessed with a small set of standard techniques. Reverse-phase high-performance liquid chromatography gives a purity estimate from peak area, usually recorded at 214 or 220 nanometers, where the peptide bond absorbs. Mass spectrometry confirms the expected molecular mass and can reveal truncated or oxidized species. Amino acid analysis or tandem mass spectrometry sequencing can verify the sequence itself. Additional quality attributes include water content, residual trifluoroacetic acid carried over from purification, and endotoxin where the material is intended for biological work.
The compound is most often distributed as a lyophilized powder, appearing white to off-white and forming a loose cake or fluffy solid. It is hygroscopic to some degree, so brief exposure to humid air can add water weight and complicate weighing. The peptide dissolves readily in water and in neutral aqueous buffers, and aqueous solubility is generally described as high, well above the concentrations used in typical assays. Some polar organic solvents are also usable, which matters when a concentrated stock is prepared before dilution into buffer.
Once in solution, short peptides are generally less stable than the dry powder, and repeated freeze-thaw cycles are a common cause of loss. Laboratory guidance usually calls for aliquoting on first dissolution and storing aliquots at -20 °C or below, away from light. Adsorption to plastic and glass surfaces can lower measured concentration, particularly at low concentrations, so container material and buffer choice can affect results. Visible cloudiness, colour change or unexpected precipitate is a signal to re-check the material.
Purity is normally assessed by reversed-phase HPLC, with the main peak reported as a percentage of total peak area, while identity is confirmed by mass spectrometry. Electrospray and MALDI-TOF instruments are both used, and the observed mass is compared with the value calculated from the stated sequence. Ion-exchange or size-exclusion methods appear where aggregation or charge variants are of interest. Water content, counter-ion content and residual trifluoroacetate from purification are separate variables that can shift the measured mass and should be weighed when reading a certificate of analysis.
Research peptides are typically supplied as a white to off-white lyophilised powder in a sealed vial. The dry solid is more stable than a solution and is normally kept refrigerated or frozen until use. Dissolution is usually done in water, phosphate-buffered saline or a similar aqueous medium, depending on the assay. Because the material is hygroscopic and easily contaminated, opening vials in a low-humidity environment and recording the lot number before use are standard laboratory practices.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white powder | Lyophilized cake or fluffy solid |
| Water solubility | High | Dissolves in water and neutral buffers |
| Dry storage | -20 °C or below | Dry, dark, desiccated |
| Reconstituted storage | Frozen, single thaw | Repeated freeze-thaw promotes loss |
| Purity method | Reverse-phase HPLC | Peak area read at 214 or 220 nm |
Detection in biological matrices generally relies on liquid chromatography coupled with tandem mass spectrometry, because the peptide lacks a convenient ultraviolet chromophore beyond the amide backbone. Immunoassays have been described, but antibodies raised against the fragment can cross-react with the full-length protein or with unrelated peptides, so findings usually require confirmation by a second technique. Sample preparation typically involves protein precipitation followed by solid-phase extraction. Reported detection windows depend on dose, route, matrix, and instrument sensitivity.
Lyophilised material is stable for extended periods when kept dry and cold, and suppliers typically recommend storage well below freezing. Once dissolved, the peptide is handled at refrigeration temperatures and used within a short period, because peptide bonds and the acetylated terminus can be affected by repeated freeze-thaw cycles, proteases, or extreme pH. Bacteriostatic water and saline are both described as solvents, although preservatives can interfere with some analytical workflows. Reconstituted solutions are inspected for particulates before use.
The seven-residue chain carries several polar and charged side chains, so it dissolves readily in water and in aqueous buffers near neutral pH. No cysteine is present, so disulphide formation is not a concern and reducing agents are unnecessary. Dilute ammonium hydroxide or acetonitrile-water mixtures are sometimes used for stock solutions when initial dissolution is slow. Strongly alkaline conditions and prolonged contact with oxidising agents are avoided because they can modify lysine-containing stretches, and haze in solution usually signals incomplete dissolution or aggregated material.
Identity and purity are checked with reversed-phase high-performance liquid chromatography, which separates the target sequence from truncated or deletion analogues, and with mass spectrometry, which confirms the expected molecular mass. Amino acid analysis and peptide mapping give orthogonal confirmation but are used less often outside specialist laboratories. Counter-ion content varies: material purified on trifluoroacetic acid gradients retains trifluoroacetate, and ion exchange can convert the salt form. Residual water and solvent are measured by Karl Fischer titration or thermogravimetric analysis, and any purity figure should be read together with the method used to obtain it.
Lyophilised peptide powders are hygroscopic, and the fragment absorbs atmospheric moisture when a vial is opened at room temperature. Weighing and aliquoting are normally done quickly in a dry environment, and stock solutions are divided into single-use portions before freezing. Repeated freeze-thaw cycles are avoided because they promote aggregation and can shift the measured content of a vial. These practices are general to synthetic peptides rather than unique to this sequence, but they matter more for short chains kept for long periods.
No major regulatory agency has approved TB-500 for therapeutic use, and it holds no pharmacopoeial monograph. The name appears on the World Anti-Doping Agency prohibited list within the class covering peptide hormones, growth factors, and related substances. Detection in doping control relies on mass spectrometric methods applied to urine, often after preparation steps that concentrate the analyte. Discussion of TB-500 therefore clusters in biochemistry, sports medicine, and anti-doping literature rather than in registered clinical trials.
TB-500 is a synthetic peptide preparation marketed under a name derived from thymosin beta-4, a 43-residue actin-binding protein first isolated from thymus tissue. The full-length protein has a reported molecular mass near 4963 Da, while material sold as TB-500 is often described as a fragment containing the actin-binding motif LKKTETQ. Because suppliers use the name inconsistently, published sources sometimes refer to the same label as a fragment, a synthetic copy, or a related analog. This naming ambiguity complicates direct comparison of reports across studies.
Laboratory work on thymosin beta-4 describes binding to monomeric actin and effects on cell migration, angiogenesis, and inflammatory signaling in cultured cells. Animal models have examined skin, corneal, and cardiac repair after injury, with outcomes reported mainly in preclinical literature. Most of that evidence concerns the parent protein rather than preparations labelled TB-500, so extrapolation from animal findings to a specific commercial product remains uncertain. Whether the two behave identically in living systems has not been established in controlled human studies.
This results in adrenal suppression and atrophy and, upon glucocorticoid discontinuation, temporary adrenal insufficiency. Similarly, CPA both in animals and humans can weakly reduce ACTH and cortisol levels and decrease adrenal gland weight as well as cause adrenal insufficiency with discontinuation. These findings suggest that CPA possesses weak glucocorticoid properties. CPA has been reported to be an antagonist of the glucocorticoid receptor (GR) in vitro and may reduce adrenal cortisol and corticosterone production by weakly inhibiting the enzymes 3β-hydroxysteroid dehydrogenase and 21-hydroxylase. These are antiglucocorticoid actions. However, metabolites of CPA, for instance 15β-hydroxycyproterone acetate, may have differing activities. Both cyproterone and CPA have been found to possess glucocorticoid effects, and based on studies in mice, it has been suggested that CPA has approximately one-fifth of the potency of prednisone as a glucocorticoid. The glucocorticoid effects of CPA in humans appear to be less significant than those in animals. Megestrol acetate, medroxyprogesterone acetate, and chlormadinone acetate are all steroidal progestins of the 17α-hydroxyprogesterone family and close analogues of CPA which similarly possess glucocorticoid properties and the potential for producing adrenal insufficiency upon discontinuation.
== History == Setmelanotide was invented at Ipsen. It was initially known as BIM-22493 and then as RM-493 and IRC-022493. It was evaluated in two one-year clinical studies. The first study enrolled 10 participants with obesity and confirmed or suspected POMC or PCSK1 deficiency while the second study enrolled 11 participants with obesity and confirmed or suspected LEPR deficiency; all participants were six years or older. Most participants had lost more than 10% of their initial body weight after a year of treatment. Some participants also reported feeling less hungry. The U.S. Food and Drug Administration (FDA) granted the application for setmelanotide orphan disease designation, breakthrough therapy designation, and priority review. The FDA granted the approval of Imcivree to Rhythm Pharmaceutical, Inc.
In the most well-known demyelinating disease, multiple sclerosis, evidence suggests that the body's immune system plays a significant role. Acquired immune system cells, specifically T-cells, are found at the site of lesions. Other immune system cells, such as macrophages (and possibly mast cells), also contribute to the damage.
== O == George Andrew Olah (1927–2017), Hungarian and American chemist who worked on the generation and reactivity of carbocations via superacids; 1994 Nobel Prize in Chemistry Marilyn Olmstead (1943–2020), American chemist, expert in small-molecule crystallography Fred Olsen (1891–1986), British-born American chemist, inventor of the ball propellant manufacturing process Lars Onsager (1903–1976), Norwegian and American physical chemist and theoretical physicist who corrected the Debye-Hückel theory of electrolytic solutions, 1968 Nobel Prize in Chemistry Tony Orchard (1941–2005), British inorganic chemist whose research helped to lay the foundations of much modern consumer electronic technology Joan Oró (1923–2004), Spanish (Catalan) biochemist known for studies of the origin of life Hans Christian Ørsted (1777–1851), Danish chemist and physicist who discovered that electric currents create magnetic fields Wilhelm Ostwald (1853–1932), Baltic German physical chemist, 1909 Nobel Prize in Chemistry for contributions to the fields of catalysis, chemical equilibria and reaction velocities Larry E. Overman (born 1943), American organic chemist developing chemical reactions, particularly transition metal catalyzed reactions Geoffrey Ozin (DPhil 1967), British materials chemist known for research on nanomaterials
Sources: en.wikipedia.org
== Importance in metabolism == For soil bacteria, creatinase allows for organisms to process the carbon and nitrogen that come from animal wastes, degrading creatine that is made in the kidney, liver, and pancreas and excreted through urine. Animal tissues use creatine to buffer the charging of high-energy carriers during rapid ADP to ATP conversion, which creates 1-methylhydantoin. To avoid build up, animals excrete creatine and creatinine in urine. In humans, creatinase is used in enzymatic measurements of creatinine concentration for the diagnosis of renal and muscle diseases. The enzyme catalyzes the second step of a coupled creatine assay, which is used to monitor the filtration rate of the glomeruli of the kidneys.
However, only Lockyer proposed that the line was due to a new element, which he named after the Sun. The formal discovery of the element was made in 1895 by chemists Sir William Ramsay, Per Teodor Cleve, and Nils Abraham Langlet, who found helium emanating from the uranium ore cleveite, which is no longer regarded as a separate mineral species, but as a variety of uraninite. In 1903, large reserves of helium were found in natural gas fields in parts of the United States, by far the largest supplier of the gas. Liquid helium is used in cryogenics (its largest single use, consuming about a quarter of production), and in the cooling of superconducting magnets, with its main commercial application in MRI scanners. Helium's other industrial uses—as a pressurizing and purge gas, as a protective atmosphere for arc welding, and in processes such as growing crystals to make silicon wafers—account for half of the gas produced. A small but well-known use is as a lifting gas in balloons and airships. As with any gas whose density differs from that of air, inhaling a small volume of helium temporarily changes the timbre and quality of the human voice. In scientific research, the behavior of the two fluid phases of helium-4 (helium I and helium II) is important to researchers studying quantum mechanics (in particular the property of superfluidity) and to those looking at the phenomena, such as superconductivity, produced in matter near absolute zero. On Earth, it is relatively rare—5.2 ppm by volume in the atmosphere.
=== Response to pollution and environmental stress === Historical records indicate that X. parietina persisted in London despite severe air pollution, even when many other lichens disappeared. Mid-20th century mapping studies revealed that its distribution correlated with areas of moderate sulphur dioxide concentrations, but it was absent from the most polluted zones of central London, suggesting that while resistant to airborne contaminants, it has an upper tolerance limit. However, it is sensitive to certain pollutants, as demonstrated after the Torrey Canyon oil spill, when oil contamination and toxic dispersants caused widespread mortality on coastal rocks. Affected thalli lost their characteristic orange pigmentation, indicating chemical damage that interfered with enzymatic and protein activity, ultimately leading to detachment from the rock surface. The dispersant BP 1002, used during cleanup efforts, was later found to be highly toxic to marine life and coastal lichens. In X. parietina, its surfactant components disrupted algal cell membranes, reducing photosynthetic activity and accelerating thallus deterioration. Pollution affects both the population structure and development of X. parietina. There has been a decline in population density with increasing pollution levels; one study documented approximately 47 thalli per tree in lightly polluted zones, compared to 12 in moderately polluted areas and 9 in severely polluted regions. In unpolluted environments, the lichen completes its full life cycle, reaching maturity and old age.
Sources: en.wikipedia.org
Short transit at ambient temperature is generally tolerated, but long-term storage at room temperature is not recommended. Heat, moisture, and light all accelerate degradation. Cold, dry, dark storage is the conventional choice.
Suppliers typically quote a percentage derived from reverse-phase HPLC peak area. That figure reflects the relative amount of the main peak and does not by itself confirm identity or exclude related impurities. Mass spectrometry is commonly paired with it for confirmation.
Peptides purified by reverse-phase chromatography often carry trifluoroacetate as a counter-ion, which adds mass and can affect solubility and apparent behavior in assays. Acetate and hydrochloride forms are also offered. Knowing which form is present matters when calculating how much peptide a given weight contains.
Sealed, desiccated and protected from light, at -20 °C or lower for long-term storage. Short-term storage at refrigerator temperature is common in working laboratories.